LELY Vector - Reset after an Alarm or Emergency Stop; View the Alarm List on the Web Page; Reset the System after an Alarm

5.2011.8583.0 C
5-18 Operating Instructions
•
: this is the preferred feed block of this feed type, the Feed Grabber starts to grab from this
block when this feed type is requested.
The kitchen page has buttons to put the feed kitchen in the fill mode and buttons to set a feed block
to empty, filled and preferred.
•
the Settings page, this screen gives access to several settings. Do not change the settings.
•
return to the previous page without saving changes. This button appears in the upper left
corner when there is a page to return to.
5.4 Reset after an Alarm or Emergency Stop
5.4.1 View the Alarm List on the Web Page
1. Start the Horizon PC that is connected to the Vector.
2. Start an internet browser, for example Windows Internet Explorer.
3. Type the Web page address: 10.4.1.85.
4. The Web page has two tabs:
• The tab Version shows the software versions of the software that runs on the power distribution
box (PDB) and on all devices of the Vector. In some occasions refresh the page (push F5) to view all
software versions.
• The tab Alarms shows the last 100 alarms.
5.4.2 Reset the System After an Alarm
1. Connect the smartphone (see Connect the Smartphone to Device Software on page 5-15) to the Feed
Controller.
2. If there is an alarm on the Feed Controller it is shown on the display.
3. Read the alarm message, if necessary go to chapter Troubleshooting to see what actions should be
taken to remove the cause of the alarm.
4. Push
to confirm the alarm message.
5. If there is an alarm on another device go to the page Alarms > Active alarms.
6. Check on which device the alarm is generated.
7. Push
. If necessary go to chapter Troubleshooting to see what actions should be taken to remove
the cause of the alarm.
in n o vato rs in agriculture