LELY Vector - Fill the Additives Dispenser (Freq. Pulse)

5.2011.8583.0 C
Operating Instructions 5-29
The preferred block can also be set in T4C on the tab of the Feed Kitchen.
Change the preferred storage place with the Smartphone
1. Connect the smartphone to the Feed Controller.
2. Select the page Feed kitchen> Storage places
3. Select the feed storage place.
4. Push button
Prefer
Per feed type only one feed storage place can be the preferred one.
5.5.3 Fill the Additives Dispenser (freq. pulse)
1. Remove the lid from the dispenser.
2. Fill the dispenser with a certain amount of minerals or other additives.
3. Close the lid.
4. Calibrate the additives dispenser if a new type of additive is used Calibrate the Additives Dispenser
(frequency pulse) (see page 6-25). Otherwise calibrate the additives dispenser every month.
Fill the auger
If the auger was empty, fill the auger:
1. Connect the smartphone (see Connect the Smartphone to Device Software on page 5-15) to the Feed
Controller.
2. Take the Feed Controller out of Operation.
3. Go to the page Service >FreqCon Pulse >Test FreqCon Pulse.
4. Push
A window appears with the number of the dispenser.
5. Push the white box that displays the number, set the number and push OK.
6. Push button
PREFILL to start the motor and fill the pipe.
7. Wait until additives fall from the drop pipe and the auger is filled.
8. Push button
PREFILL to stop the motor.
9. Put the Feed Controller in operation.
in n o vato rs in agriculture