LELY Vector - Operating Instructions; Start up and Stop; Put the Feed Kitchen in Operation

5.2011.8583.0 C
Operating Instructions 5-1
5 Operating Instructions
5.1 Start Up and Stop
5.1.1 Put the Feed Kitchen in Operation
Unexpected movement of machines.
Risk of serious injury.
Make sure the feed kitchen is void of persons, animals, machines or anything other
than roughage.
1. Make sure the feed kitchen is void of persons, animals, machines or anything other than roughage.
2. Close all feed kitchen doors and the safety fence.
3. On the console, push start (1) (see figure 36 on page 5-2), the system checks if all gates and doors are
closed and the start button blinks quickly.
4. When the start button no longer blinks, push start (1) again, the system starts.
While the Feed Grabber and Bridge Crane start up the orange light is on.
When the green signal light is continuously on the system is started.
If the orange light stays on after waiting 2 minutes, at least one of the devices is not in
operation yet. Make sure the devices in your Vector system are in operation, for example
the Mixing and Feeding Robot(s), Feed Controller, Feed Grabber, Bridge Crane. Connect
your smartphone to each device and check.
When the feed kitchen is put in operation after it was in the fill mode, all storage
locations in the feed kitchen are marked as filled. The Feed grabber will start grabbing at
the same storage location of each feed type that is used before the kitchen was filled.
The Feed Grabber will scan the storage location before grabbing.
in n o vato rs in agriculture