5.2011.8583.0 C
Preface 7
Preface
Manual Contents
This manual contains the technical information, operating instructions, maintenance procedures and the
troubleshooting information necessary to operate the Vector system.
The information in this manual is for operators.
Study and understand this information thoroughly before you operate the Vector.
Failure to do so could result in damage to equipment or personal injury (see Signal
Icons on page 2-1). Please consult your local Lely service provider if you do not
understand the information in this manual, or if you need additional information.
Store this manual in a safe place for future reference.
All information in this manual has been compiled with care. Lely shall not be liable for errors or faults in
this manual. The recommendations are meant to serve as guidelines. All instructions, pictures and
specifications in this manual are based on the latest information that was available at the time of
publication. Your Vector may comprise improvements, features or options that are not covered in this
manual.
Applicability
The table below shows the type numbers of the parts of the Vector for which this manual is applicable.
Model Type number
Mixing and Feeding Robot 1 Phase
5.2011.0054.1
Mixing and Feeding Robot 3 Phase
5.2011.0055.1
Mixing and Feeding Robot 1 Phase (short feed mixer)
5.2011.0056.1
Mixing and Feeding Robot 3 Phase (short feed mixer)
5.2011.0057.1
Feed Grabber Laser
5.3004.0000.1
Fixed Rail (single)
5.2013.0800.1
Bridge Crane
5.2013.0210.1
Bridge Crane 2
5.2013.1110.0
Power Distribution Box 3 PhN 400/230 VAC
5.2011.0532.0
Power Distribution Box 2 Ph 240 VAC SP
5.2011.1174.0
This manual is applicable for software version 3.0 or higher.
Standard Torque Loading of Parts
All the nuts, bolts and screws used on the system are torque tightened to standard torque loadings
applicable to the construction materials used.
If a part has a non-standard torque loading, it is specified in the applicable part of the manual.
in n o vato rs in agriculture
To Next Page
Loading...
