LELY Vector - Clean the Magnets

5.2011.8583.0 C
6-4 Maintenance Procedures
Figure 54. Dosing roll and position sensor
KEY: 1. Position sensor - 2. Metal arm - 3. Dosing roll
Close-up
1. Close the door and install the bolt.
2. Switch on the Mixing and Feeding Robot with the key (see Switch on the Mixing and Feeding Robot
with the Key on page 5-14).
6.2.3 Clean the Magnets
Tools
Preparation
1. Push the pause button (see figure 37 on page 5-5) once to take the Mixing and Feeding Robot out of
operation.
in n o vato rs in agriculture