5.2011.8583.0 C
Operating Instructions 5-31
An extra margin is already taken into account when the light switches off. It is therefore
not recommended to make any extra turns. Keep on turning will cause an overload and
may damage the safety fence.
If for any reason the tension on the net drops significantly or the fence is opened when the system is not
in the filling mode, the light (1) will go on and an alarm will follow immediately.
If the light went on, you must turn the winch to put tension on the net until the light goes off.
It is possible to put the Vector into operation when the light is on. In that case, there is enough tension to
have a safe situation, but the tension is insufficient for a reliable system. Safety related alarms are
triggered much sooner in that case.
Always turn the winch until the light goes off, before you put the feed kitchen in operation.
Closing the safety fence
Tension on the net Status of the system Light on the tension pole
1
Insufficient tension Unsafe and unreliable
On
2
Insufficient tension Safe but unreliable
On
3
Sufficient tension Safe and reliable Off
5.6 Start a Feed or Scan Task Manually
After all Vector setting are made in T4C for automatic operation, it is also possible to start manual tasks
with the Feed Controller software.
T4C settings necessary for the Vector are:
• Settings for the routes (fences, scan interval).
• Settings for the feed fences (locations with animals, rations, feed height).
• Settings for the feed kitchen (storage location of feed types).
• Settings for the rations (amounts of feed types mixing order, mixing times).
• Library settings for feed types.
5.6.1 Start a Feed Task Manually with the WebUI
1. Start the WebUI (see page 5-16).
in n o vato rs in agriculture
To Next Page
Loading...
