5.2011.8583.0 C
Maintenance Procedures 6-5
Clean
Figure 55. Magnets
1. Push all metal parts upwards and remove them from the magnets (1) (see figure 55 on page 6-5).
Close-up
1. Push the pause button once to put the Mixing and Feeding Robot in operation.
6.2.4 Clean the Feed Height Sensor
Laser light.
Risk of getting blind.
Do not stare into the beam.
Preparation
1. Take the Mixing and Feeding Robot out of operation (see Take the Mixing and Feeding Robot Out of
Operation on page 5-4).
2. Push the button (2) (see figure 56 on page 6-6) on the laser cover (1) to release the lock, lift (A) and
pull (B) the laser cover.
in n o vato rs in agriculture
To Next Page
Loading...
