LELY Vector - Reset an Emergency Stop Button in or Near the Feed Kitchen

5.2011.8583.0 C
5-26 Operating Instructions
6. A question appears: Continue with current route?.
Select:
• Yes, to let the Feeding Robot continue the route
• No, to stop the route. You must manually drive the Mixing and Feeding Robot to the charger and
put it in operation (see Put the Mixing and Feeding Robot In Operation on page 5-2)
• MANUAL DRIVING, to drive the Feeding Robot manually to a location on the route.
1. The following message appears on your display: SAFETY WARNING Manual operation is
permitted only with a clear overview of the vehicle. Confirm?
2. Confirm if you have a clear overview of the Mixing and Feeding Robot.
3. Drive the robot manually to the location where the Feeding Robot interrupted the route.
4. Push button
.
5. Select Yes to continue the route.
6. Push pause button (2) (see figure 41 on page 5-11) twice.
7. If the Feeding Robot now generates an alarm because the reset point or strip can not be found
but the reset point or strip is very near by, repeat this procedure.
7. If necessary reset the MODalarm (see Reset alarms on the MODalarm on page 5-23) or the alarm on
CRS.
5.4.7 Reset an Emergency Stop Button in or near the Feed Kitchen
Unexpected movement of machines.
Risk of serious injury.
Make sure the feed kitchen is void of persons, animals, machines or anything other
than roughage.
1. Pull the emergency stop button out until it locks.
2. Make sure the feed kitchen is void of persons, animals, machines or anything other than roughage.
3. Make sure the safety fence is closed.
4. Make sure all gates and feed kitchen doors are closed.
5. If necessary reset the MODalarm (see Reset alarms on the MODalarm on page 5-23) or the alarm on
CRS.
6. On the console push start (1) (see figure 36 on page 5-2).
The start button starts blinking and the system tests if all gates are closed and emergency stop
buttons are in safe position.
7. Wait until the light in the start button is continuously on.
If necessary manually put the feed Grabber and/or Bridge Crane in operation.
8. On the console push start again.
in n o vato rs in agriculture