LELY Vector - Installation of Safety Decals; Maintenance of Safety Decals; Safety Devices; Feed Grabber

5.2011.8583.0 C
Safety 2-11
2.3.8 Installation of Safety Decals
1. Make sure that the installation surface is clean and dry.
2. Make sure that the temperature of the mounting surface is not less than 5 °C (41 °F).
3. Find the correct position for the decal before you remove the backing paper.
4. Remove a small part of the cover paper.
5. Put the decal in the correct position on the installation surface and carefully push the small part of
exposed adhesive surface of the decal onto the installation surface.
6. Slowly remove the cover paper and attach the rest of the decal to the installation surface.
7. Puncture small air pockets in the decal with a pin and use the cover paper to smoothen the decal.
2.3.9 Maintenance of Safety Decals
Safety decals show important and useful information that will help you to safely operate and maintain the
machine.
Obey the instructions below to make sure that all the decals stay in the correct position and condition.
• Keep the safety decals clean and legible at all times. Clean the safety decals with soap and water. Do
not use mineral spirits, abrasive cleaners or other similar agents that may damage the safety decals.
• Replace safety decals that are missing or that are illegible.
• Safety decals can be purchased from your local Lely service provider.
2.4 Safety Devices
2.4.1 Feed Grabber
2.4.1.1 Handles to manually open the Grabber in case of Emergency
Sudden release of jaws.
Risk of personal injury.
Only use the handles in case of an emergency. Stand as far away from the jaws of the
grabber as possible to prevent getting hit by a released jaw.
Only open the grabber in case of an emergency because the chain will fall out and it
takes some time to reinstall the chain.
1. Stop the system by pushing an emergency button.
in n o vato rs in agriculture