5.2011.8583.0 C
Operating Instructions 5-33
5.6.2 Start a Feed Task Manually with the Smartphone
1. Connect the smartphone (see Connect the Smartphone to Device Software on page 5-15) to the Feed
Controller.
2. Go to the page Manual tasks.
3. Push button
Feed.
4. If more than 1 route is available:
Use the buttons
and and push Select to select a route.
A page appears with the fences with animals on the route.
5. Use the buttons
and and push Add to add a fence to the task list.
6. If one fence is selected, it is possible to add another fence if there is another fence in the same
feedsection on the route with the same ration.
The fences that can not be combined have - - signs behind them.
7. When all fences are added, push
Done
All tasks are shown in the order of execution.
The tasks start when the Mixing and Feeding Robot is in operation and connected to the charger under
the feed loading point and the feed kitchen is in operation.
When all the tasks are done, the system will continue to work automatically.
5.6.3 Start a Scan Task Manually with the WebUI
1. Start the WebUI (see page 5-16).
2. Push the button
Fences.
3. Push the button Add a task.
4. Select the route or combined routes in the drop down list.
5. Push the button Add scan task.
All tasks are shown in the order of execution.
The tasks start when the Mixing and Feeding Robot is in operation and connected to the charger under
the feed loading point, the PDB (Feed Controller) is in operation and the feed kitchen is in operation.
When all the tasks are done, the system will continue to work automatically.
If you want to delete a manual task in the list, push the button
at the end of a line.
5.6.4 Start a Scan Task Manually with the Smartphone
1. Connect the smartphone (see Connect the Smartphone to Device Software on page 5-15) to the Feed
Controller.
2. Go to the page Manual tasks.
in n o vato rs in agriculture
To Next Page
Loading...
