5.2011.8583.0 C
Operating Instructions 5-25
4. A question appears: Continue with
Select:
• Yes, to let the Feeding Robot continue the route.
• No, to stop the route. You must manually drive the Mixing and Feeding Robot to the charger and
put it in operation (see Put the Mixing and Feeding Robot In Operation on page 5-2).
• MANUAL DRIVING, to drive the Feeding Robot manually to a location on the route.
1. The following message appears on your display: SAFETY WARNING Manual operation is
permitted only with a clear overview of the vehicle. Confirm?
2. Confirm if you have a clear overview of the Mixing and Feeding Robot.
3. Drive the robot manually to the location where the Feeding Robot interrupted the route.
4. Push button
.
5. Select Yes to continue the route.
6. Push pause button (2) (see figure 41 on page 5-11) twice.
7. If the Feeding Robot now generates an alarm because the reset point or strip can not be found
but the reset point or strip is very near by, repeat this procedure.
5. If necessary reset the MODalarm (see Reset alarms on the MODalarm on page 5-23) or the alarm on
CRS.
5.4.6 Reset the Emergency Stop Button on the Mixing and Feeding Robot
Unexpected movement of vehicle.
Risk of personal injury.
Make sure the Mixing and Feeding Robot and the immediate vicinity is void of persons
and animals. Only operate the Mixing and Feeding Robot with the smartphone when it
is in your line of sight.
1. Make sure the Mixing and Feeding Robot and the immediate vicinity is void of persons and animals.
2. Turn the emergency stop button (1) (see figure 41 on page 5-11) clockwise and pull it out until it locks.
3. Connect the smartphone (see Connect the Smartphone to Device Software on page 5-15) to the Mixing
and Feeding Robot.
4. Read the alarm message.
5. Push
to confirm the alarm message.
in n o vato rs in agriculture
To Next Page
Loading...
