5.2011.8583.0 C
2-4 Safety
• Keep tools and metal parts away from the battery.
• Do NOT use a high pressure cleaner when you clean the Mixing and Feeding Robot on the outside.
• Make sure all covers are installed when maintenance work is completed.
2.2.3 Cut Resistant Clothing
The cut resistant clothing must comply with the standards in the table below.
Symbol Applies to Information about level of protection, class and design
Gloves EN
388–5
Cut resistant gloves according to EN 388 level 5 (or ANSI 105 level A7)
Level 5 indicates the glove provides the highest level of cut resistance.
Sleeves EN
388–5
Cut resistant sleeves according to EN 388 level 5 (or ANSI 105 level A7)
Level 5 indicates the sleeve provides the highest level of cut resistance.
Trousers EN
381–5
Overall EN
381–5
Chainsaw trousers according to EN 381–5:
• All classes are sufficient, class 0 (16 m/s) to 3 (28 m/s).
• Design C is mandatory, this design has protection all around.
Jacket EN
381–11
Chainsaw jacket according to EN 381–11 preferably with belly protection.
2.2.4 Cranes and Feed Grabber Safety Instructions
Operating safety
• Do not enter the operating area of the Bridge Crane and Feed Grabber when the system is not in
kitchen fill mode.
• Do not bypass/ tamper with the safety systems in any way.
• Do not block the Crane or Feed Grabber. It can move with sufficient force and can cause injury.
• Do not climb the Crane.
Maintenance safety
• Have the crane inspected annually.
• Do NOT touch the motors until they are cooled down.
• Use the Vector stepladder to work on the Crane and Feed Grabber.
in n o vato rs in agriculture
To Next Page
Loading...
