5.2011.8583.0 C
6-22 Maintenance Procedures
2. If there is a Bridge Crane present:
1. Connect the smartphone to the Bridge Crane.
2. Take the Bridge Crane out of operation (see procedure).
3. Go to the page Manual operation > Driving.
4. Drive the Bridge Crane to the Y position of the feed loading point.
3. Connect the smartphone to the Feed Grabber.
4. Go to the page Testing > Test Drive Motor.
5. Use the buttons
BACKWARD or FORWARD to drive the Feed Grabber to the feed loading
point.
Use the button to go to the previous menu.
6. Go to the page Testing > Test Grabber.
7. Use the buttons
OPEN and CLOSE to open or close the grabber
Open the grabber to a percentage between 60 and 65%.
8. Go to the page Testing > Test Lift Motor.
9. Push the button
DOWN to lower the grabber to a height where you can easy clean the jaws.
Clean the grabber
Figure 66. Clean the jaws
KEY: 1. Jaws
1. Use a (wall) scraper or putty knife to remove all
feed remains from the jaws (1). Clean the inside
and outside of the jaws.
Close up
1. Connect the smartphone to the Feed Grabber.
in n o vato rs in agriculture
To Next Page
Loading...
