Lenovo ThinkSystem SR665 V3 - Page 108

• Prevent exposure to static electricity, which might lead to system halt and loss of data, by keeping static-
sensitive components in their static-protective packages until installation, and handling these devices with
an electrostatic-discharge wrist strap or other grounding system.
Procedure
Step 1. Touch the static-protective package that contains the new part to any unpainted surface on the
outside of the server. Then, take the new part out of the package and place it on a static-protective
surface.
Step 2. Install the front OCP interposer card on the front OCP cage, and connect cables to the card. See
Chapter 6 “Internal cable routing” on page 281.
Figure 55. Installing the front OCP interposer card
a. Lower the front OCP interposer card onto the front OCP cage.
b.
Tighten the screws to secure the front OCP interposer card.
Step 3. Install the OCP module.
98
ThinkSystem SR665 V3 User Guide