Lenovo ThinkSystem SR665 V3 - Page 78

Rack front
Figure 25. Installing the server into the rails
a.
Tilt the server and slowly lower its rear end; then, push the rails toward the server and make
sure the farthest nailheads on server’s left and right side go into the slots on the rail.
b.
Slowly lower the server down and make sure the other three nailheads on server’s left and
right sides slip into corresponding slots.
Note: Inspect the sides of the rails to make sure the nailheads are placed in the slots.
Step 4. Slide the server into rack.
Figure 26. Installing the server into the rack
1
Latch
a.
Push up the latches on the rails.
68 ThinkSystem SR665 V3 User Guide