b. Push the server all the way into the rack until both latches lock into position with a click.
Step 5. (Optional) Secure the server to the rack.
a. Install one M6 screw to each of the rails to secure the server to the rear of the rack.
Rack rear
Figure 27. Securing the server to the rear of the rack
b. Fasten the two thumbscrews located on the front of the server.
Rack front
Figure 28. Securing the server to the front of the rack
1
Rack latch
2
Screw
After you finish
Chapter 5. Hardware replacement procedures 69
To Next Page
Loading...
