Available options:
• Single Pass Erase—overwrites all data and the file system. This wipe is faster but less secure since it is possible to
retrieve the deleted data with forensic data‑retrieval techniques.
• Multi Pass Erase—overwrites all data without rewriting the file system. This wipe is DoD 5220.22-M compliant since
the deleted data is irretrievable.
Note: If the printer is reset while a disk wipe operation is executing, then Corrupt Disk appears upon regaining
power.
Wipe All Settings
This makes any sensitive information that may exist on the volatile or non-volatile storage of the device completely
indecipherable. When selected, the printer performs a non‑critical NVRAM reset and then reboots.
Font Density
This creates microscopic holes in all black text. The holes save toner by reducing overlapping toner.
Available options: 1 to 5
Font Sharpening
This allows a user to set a text point-size value below which the high‑frequency screens will be used when printing font
data.
Available options:
• Off
• On
Reduced Curl
When on, this setting significantly reduces throughput and should be activated only as a last resort to solve paper curl
problems. The printer uses this mode only when the media type is set to Paper.
Available options:
• Off
• On
Require Standby
Note: This setting is available on the MS610de model only.
This sets Standby Mode to On or Off. The default is On.
To change the setting:
1 From the Configuration menu, navigate to Require Standby.
2 Select On or Off to change the setting.
4514-630, -635, -636
Service menus
142
To Next Page
Loading...
Need help?
General
