9-2
RLC-4 V1.79 Copyright © 1998 Link Communications Inc. 9/18/98
073: Set/Recall Preaccess
This command allows you to set up a repeater or link for preaccess, to turn preaccess off, or to
recall whether a port is set up for preaccess or not. This command automatically programs a macro
when you turn preaccess on port a port; anything previously in that macro will be lost. You should
also take care not to overwrite what is stored in that macro (if you do, executing this command
again will fix it). Macro 163 is used for port 1, 164 for port 2, etc. as shown below.
<073> p Recall Preaccess Settings
<073> p 0 Turn preaccess off for port ‘p’
<073> p 1 Configure port ‘p’ as a preaccess repeater
<073> p 2 d c..c Configure port ‘p’ as a preaccess link
Parameters:
- 073 is the default command name.
- ‘p’ is the port to set up or recall the settings for.
Port Macro Used
1 163
2 164
3 165
4 166
- ‘d’ is 0 for no preaccess tone when accessed, 1 for preaccess tone
- “c..c” is the site access code. Typical site access codes are "#11", "#75", "#99", etc., a '#'
followed by two decimal digits. The controller will allow any preaccess code
from 1 to 6 digits long with any of the 16 DTMF digits in it, although you
may have to change your force-execution digit temporarily (see command
078) while you execute this command to use the force-execution digit as part
of the access code.
To Next Page
Loading...
Need help?
General
