Link Communications RLC-4 - 009: Recall Entire Controllers Audio Crosspoint

2-10
RLC-4 V1.79 Copyright © 1998 Link Communications Inc. 9/18/98
009: Recall Entire Controller's Audio Crosspoint
This command allows you check the audio crosspoint connections on all radio ports on the
controller. For each receiver, it shows which transmitters are connected, that is which transmitters
will be keyed by the controller when that receiver goes active.
<009>
Parameters:
- 009 is the default command name.
Default:
- None
CW Response:
The CW response will only be sent if a receiver is connected on the selected port. If a
receiver is connected to a port's transmitter, the controller will send RX "R" connect "C" TX "T"
where RX and TX are the port numbers of the receiver and transmitter, respectively.
CW Format:
1 'C' <TX1> <TX2> <TX3> <TX4>
2 'C' <TX1> <TX2> <TX3> <TX4>
3 'C' <TX1> <TX2> <TX3> <TX4>
4 'C' <TX1> <TX2> <TX3> <TX4>
Serial Format:
TX 1 2 3 4
RX 1 . . . .
2 . . . .
3 . . . .
4 . . . .