13-4
RLC-4 V1.79 Copyright © 1998 Link Communications Inc. 9/18/98
(ACD) ### - where the "ACD" is the allowed area code, and the ### says to ignore the
prefix following the area code.
Nuisance Number Disallow Table:
The RLC-4 supports a 10 nuisance number dis-allow table. If the user enters a number that
is found in the nuisance table, the controller will refuse to dial that number with command 112. The
number can vary from 1..11 digits in length.
Other Commands that Affect the Autopatch:
Command 007 (see Chapter 3) allows you to turn the DTMF mute on or off for the autopatch port.
While this does not affect the DTMF digits that are actually generated when the autopatch is
dialing, it does have several other effects. See the note on command 007 for more information.
To Next Page
Loading...
Need help?
General
