14-2
RLC-4 V1.79 Copyright © 1998 Link Communications Inc. 9/18/98
Using the RBI-1 or RLC-ICM:
Using the RBI-1 or RLC-ICM (after it is set up) is very straightforward. There are separate
commands to do each of the following tasks:
139 - RLC-ICM setup
140 - radio on/off, tx power low/med/high, offset format
141 - pl freq code, tx on/off, rx on/off
142 - set freq or recall memory
143 - recall current frequency or memory
If there are combinations of settings that you use often, you can program them into the memories
on the Kenwood radios (if you are using the RBI-1) or you can program user macros to select those
settings, making the controller's macro work like a memory.
To Next Page
Loading...
Need help?
General
