6-9
RLC-4 V1.79 Copyright © 1998 Link Communications Inc. 9/18/98
043: Set CW Tone Frequencies for a Selected Port
This command allows you to set up the CW tone frequencies used by the CW system.
<043> p aaaa
Parameters:
- 043 is the default command name.
- P is the selected port (1..4)
- AAAA is the first tone frequency (0000..9999) Hz
Default:
Tone 1 is set to 1064 Hz.
Alternate Entries:
If a single tone CW frequency chord is wanted, only enter 1 frequency
- 043 P AAAA <unkey>
CW Response:
There is no CW response to this command
Note:
If a macro sets the CW frequecy to 500 Hz with this command, sends a CW message
(message 1), then changes the CW frequency to 1000 Hz and sends message 2, message 1 will be
sent at 500 Hz and message 2 will be sent at 1000 Hz, as you might expect. In other words, this
command does not change the CW frequency immediately when it is executed; it changes it at the
logical place in the CW message. It will not change the frequency of a message that is already in
the process of being sent.
To Next Page
Loading...
Need help?
General
