Link Communications RLC-4 - 011: Recall Command Name; 012: Find Commands Named

5-9
RLC-4 V1.79 Copyright © 1998 Link Communications Inc. 9/18/98
011: Recall Command Name
This command allows you to recall the name of a command. It also tells you whether it requires
more digits to be entered after the command name, if so how many, and whether more digits than
that will be accepted. You specify the command number (the number of the command in this
manual) and the controller will look up its name.
<011> xxx
Parameters:
- 011 is the default command name.
- XXX is the command number ranging from 000-249
CW Response:
The CW response is XXX 'IS' YYYYYY 'ED' (Number of Digits of Extra Data)
-- "ED" signifies that the following number is the amount of additional data needed for that
command.
-- If the letter "V" is sent, the next number sent is the minimum data accepted.
-- If the letter "C" is sent, the command is not found.
012: Find Commands Named ...
This command tells the controller to find all of the commands that have the name you specify.
Normally it will only find one command, but if you have several commands with the same name, it
will list them all.
<012> y..y
Parameters:
- 012 is the default command name.
- Y..Y is the command name with default command name of 000-249
CW Response:
The CW response is "Command Number (000-249)" IS "Y..Y ".