Link Communications RLC-4 - Command List by Number

RLC-4 V1.79 Copyright © 1998 Link Communications Inc. 9/18/98
Command List by Number
000: Connect one Port to another Port ...........................................2-3
001: Monitor one Port from another Port .........................................2-4
002: Disconnect one Port from another Port .......................................2-5
003,004: Recall a Port's Connections ............................................2-6
005: Set Receiver and DTMF Decoder Conditions ..................................2-7
006: Recall Receiver and DTMF Decoder Conditions ................................2-9
007: Configure DTMF Mute/Cover Tone/Bypass ...................................3-3
008: Not Currently Used ....................................................17-7
009: Recall Entire Controller's Audio Crosspoint ..................................2-10
010: Re-Program Command Names .............................................5-5
011: Recall Command Name ..................................................5-9
012: Find Commands Named ... ................................................5-9
013: Set COR and PL Active Levels ............................................2-11
014..019: Not Currently Used ................................................17-7
020: Program a Selected Timer ................................................4-2
022: Start a Timer .........................................................4-11
023: Stop a Timer .........................................................4-12
024: Set Up RS-232 Serial Baud Rate ...........................................7-2
025: Record a Message on the Small DVR ......................................6-14
026: Playback Small DVR Message(s) ..........................................6-15
027: Erase Small DVR Message(s) ............................................6-15
028, 029: Not Currently Used ................................................17-7
030: Send a CW Message .....................................................6-2
031: Send a DTMF Sequence Out Port 4 .........................................6-3
032: Send Serial Message out the Serial Port ......................................7-4
033: Enable or Disable PTT for a Port ..........................................2-13
034: Recall Which PTT are Enabled ...........................................2-13
035: Remotely Reset the Controller ............................................17-1
036: Not Currently Used ....................................................17-7
037: Set Audio Routing Variable for Commands In a Macro ........................16-1
038: Kill All Responses Following This Command .................................16-2
039: Recall the Ports in the Current Audio Routing Variable .........................16-4
040: Send a Tone ..........................................................6-4
041: Courtesy Beep Enable/Disable for a Selected Transmitter .........................6-7
042: Set CW Speed for a Selected Port ..........................................6-8
043: Set CW Tone Frequencies for a Selected Port .................................6-9
044: Set Up DTMF Regenerate Parameters: .....................................6-10
045: Set/Recall Event Trigger ................................................20-2
046: Default Event Trigger Action .............................................20-2
047: Enable/Disable Event Trigger ............................................20-2
048,049: Not Currently Used .................................................17-7
050: Set Up or Recall Default Audio Routing Variables .............................16-5
051: Start Preaccess Tone ..................................................6-11
052: Not Currently Used ....................................................17-7
053: Program a Single Command Macro Sequence .................................8-6
054: Recall Macro Contents ..................................................8-7