Link Communications RLC-4 - Page 12

RLC-4 V1.79 Copyright © 1998 Link Communications Inc. 9/18/98
055: Delete Macro ......................................................... 8-8
056: Append a Command to a Macro ........................................... 8-8
057: Copy a Macro ......................................................... 8-8
058: Delete a Command in a Macro ............................................ 8-9
059: Insert a Command in a Macro ............................................. 8-9
060: Set Up Serial Port Options ............................................... 7-3
061: Disconnect all Ports from a Radio Port ..................................... 2-12
062: Change the Beginning of Command Names ................................... 5-7
063, 064: Not Currently Used ................................................ 17-7
065: Restore Audio Routing Variable (Undo 037 and 038) .......................... 16-3
066..072: Not Currently Used ................................................ 17-7
073: Set/Recall Preaccess .................................................... 9-2
074: Allow Access To a Port that Requires Preaccess ............................... 9-3
075: Set Stop Access Conditions .............................................. 9-4
076: Recall Stop Access Conditions ............................................ 9-5
077: Isolate a Port from the Rest of the System ................................... 9-5
078: Set Command Entry Options for a Port ..................................... 17-2
079: Recall Command Entry Options for a Port .................................. 17-4
080: Execute Command by Number ............................................ 17-5
081..084: Not Currently Used ................................................ 17-7
085: Enable/Disable IDing a Port ............................................. 11-3
086: Recall Which Ports have ID's Enabled ...................................... 11-3
087..089: Not Currently Used ................................................ 17-7
090: Read Whether Input Line is High or Low ................................... 12-5
091: Execute Input Line High or Low Macro .................................... 12-5
092: Not Currently Used ................................................... 17-7
093: Turn Output Line On .................................................. 12-6
094: Turn Output Line Off .................................................. 12-6
095: Recall Whether Output Line is On or Off ................................... 12-7
096..099: Not Currently Used ................................................ 17-7
096: Control or Recall Extended Output Lines ................................... 12-19
100: Read Analog Input Line ................................................. 12-8
101: Set Resolution For Analog Input .......................................... 12-9
102: Set Conversion Ratio For Analog Input ................................... 12-11
103: Calibrate an Analog Input .............................................. 12-14
104: Set an Analog Alarm .................................................. 12-15
105: Set Analog Alarm Hysteresis ........................................... 12-16
106: Not Currently Used ................................................... 17-7
107: Recall Analog Lines in Alarm ........................................... 12-18
108: Recall Analog Line Configuration ........................................ 12-18
109: Not Currently Used ................................................... 17-7
110: Configure the Autopatch ................................................ 13-5
111: Manual Off Hook ..................................................... 13-5
112: Normal Forward Dial .................................................. 13-6
113: Forward Dial with no Long Distance Checking ............................... 13-7
114: Hang up the Autopatch ................................................. 13-9
115: Possibly Hang up the Autopatch .......................................... 13-9
116: Set / Recall the Predial Digits and Timing .................................. 13-10
117: Forward Dial with no Long Distance Checking or Predial ....................... 13-8