RLC-4 V1.79 Copyright © 1998 Link Communications Inc. 9/18/98
Table of Contents
Command List by Number .................................................. XI
Limited Warranty .........................................................XV
Return Policy ............................................................XVI
User Survey ............................................................ XVII
Chapter 1: Getting Started ..................................................1-1
Setup, Interfacing and Adjustment ........................................1-1
Serial Port Interfacing ..................................................1-5
Reset and Power Up ...................................................1-9
Entering Commands ...................................................1-9
Error Messages ......................................................1-11
How to Configure a Port as a Repeater ....................................1-13
Example 1-1: Configuring a Port as a Repeater or Link ........................1-14
Example 1-2: Configuring a Port's COR/PL Polarity ..........................1-15
How to program your Beeps and Messages .................................1-16
System Timers ......................................................1-17
The Autopatch ......................................................1-19
Troubleshooting the Controller ..........................................1-20
Chapter 2: Port Connection Commands .......................................2-1
"Connected Ports" ....................................................2-1
Turning a Repeater Off .................................................2-1
000: Connect one Port to another Port .....................................2-3
001: Monitor one Port from another Port ...................................2-4
002: Disconnect one Port from another Port .................................2-5
003,004: Recall a Port's Connections ......................................2-6
005: Set Receiver and DTMF Decoder Conditions ............................2-7
006: Recall Receiver and DTMF Decoder Conditions ..........................2-9
009: Recall Entire Controller's Audio Crosspoint ............................2-10
013: Set COR and PL Active Levels ......................................2-11
061: Disconnect all Ports from a Radio Port ................................2-12
033: Enable or Disable PTT for a Port ....................................2-13
034: Recall Which PTT are Enabled ......................................2-13
Chapter 3: Audio and DTMF Configurations ...................................3-1
007: Configure DTMF Mute/Cover Tone/Bypass .............................3-3
Chapter 4: Timers .........................................................4-1
020: Program a Selected Timer ...........................................4-2
021: Recall a Timer Value ..............................................4-11
022: Start a Timer ....................................................4-11
023: Stop a Timer ....................................................4-12
To Next Page
Loading...