14-12
RLC-4 V1.79 Copyright © 1998 Link Communications Inc. 9/18/98
141: Set PL Frequency, Encode and Decode
This command allows you to tell the Doug Hall RBI-1 or RLC-ICM which PL (CTCSS) frequency
to use, and whether to encode (transmit) it, decode (receive) it, neither or both.
<141> FF E D
Parameters:
- 141 is the default command name.
- FF is the PL frequency code - see the table below
- E is 1 to encode (transmit) PL, 0 to not encode it.
- D is 1 to decode (receive) PL, requiring the transmitter you are monitoring to encode it, or
0 to use carrier only.
Tone # Frequency Tone # Frequency Tone # Frequency
01 67.0 15 110.9 29 179.9
02 71.9 16 114.8 30 186.2
03 74.4 17 118.8 31 192.8
04 77.0 18 123.0 32 203.5
05 79.7 19 127.3 33 210.7
06 82.5 20 131.8 34 218.1
07 85.4 21 136.5 35 225.7
08 88.5 22 141.3 36 233.6
09 91.5 23 146.2 37 241.8
10 94.8 24 151.4 38 250.3
11 97.4 25 156.7 .... ....
12 100.0 26 162.2 .... .....
13 103.5 27 167.9 .... ....
14 107.2 28 173.8 .... ....
To Next Page
Loading...
Need help?
General
