E-3
RLC-4 V1.79 Copyright © 1998 Link Communications Inc. 9/18/98
I/O line 1, the direction reading you wrote down is DDDD and the CW macro number will
be CCC.
055 MMM D or unkey (erase the old contents)
056 MMM 104 1 1 0 xxxx D or unkey (make the macro set the high alarm point)
056 MMM CCC D or unkey (make the macro start the rotor clockwise)
• Turn the rotor all of the way CCW with the CCW macro. From now on you can use this
macro as a "reset rotor" command. You will need to execute it and wait for it to finish
turning all of the way CCW before you tell the rotor to go to each new preset. You may
want to change the name of this macro with Command 110.
• Now try the preset we set two steps ago by executing macro MMM. It should start the
rotor turning clockwise. The high alarm should stop it when it gets to the proper position.
• Reset the rotor and try the preset again. If everything works, rename the preset macro
(MMM) to some descriptive name with Command 010 and make more presets.
To Next Page
Loading...
Need help?
General
