Lucent Technologies DDM-2000 OC-3 User Manual

NTP-010: Circuit Order 363-206-285
Page 7 of 8 Issue 2, February 2000
DDM-2000 OC-3 MULTIPLEXER
DO ITEMS BELOW IN ORDER LISTED. . . . . FOR DETAILS, GO TO
NOTE:
The following commands may be used to delete, enter, and
retrieve cross-connections: dlt-crs-sts1,
dlt-crs-vt1, ent-crs-sts1, ent-crs-vt1,
rtrv-crs-sts1, and rtrv-crs-vt1.Seethe
Commands and Reports section of this manual for a
description of commands. See Cross-Connection
Provisioning in the Administration and Provisioning section
of this manual for more information on cross-connection
provisioning.
Determine the necessary cross connections for each node from
the work order or circuit order.
17. If required, use the ent-crs-( ): command(s) at each shelf to
make necessary STS-1 and/or DS1 (VT1.5) cross-connections.
DLP-546A. Single Ring Configuration
DLP-550B. Dual Ring Interworking (DRI) Configuration
DLP-557C. Single/Dual OC-3/FiberReach Configuration
DLP-558D. Stand Alone OC-3/FiberReach Configuration
DLP-559E. Single/Dual OC-3/OC-48 Configuration
DLP-560F. Single/Dual OC-3/OC-12 Configuration
18. Perform an end-to-end DS1 transmission test for each DS1 port
being put into service (optional).
DLP-510A. Single Ring Configuration
DLP-554B. Dual Ring Interworking (DRI) Configuration
DLP-510C. OC-3/FiberReach Configuration
19. Use the rtrv-state-eqpt: command to determine the port
state of the DS1 port(s) of the circuit being established.
DLP-546
DLP-550
DLP-557
DLP-558
DLP-559
DLP-560
DLP-510
DLP-554

Lucent Technologies DDM-2000 OC-3 Specifications

General

Brand	Lucent Technologies
Model	DDM-2000 OC-3
Category	Multiplexer
Language	English