Lucent Technologies MERLIN LEGEND Release 6.1 Installation

MERLIN LEGEND Communications System Release 6.1
Installation
555-661-140
Issue 1
August 1998
Installing the Control Unit
Page 2-36
Installing the Modules
■ E&M Mode
— Type 1 Standard (default factory setting). This setting is
used to connect two systems through local telephone
company facilities.
— Type 1 Compatible. This setting connects two systems
directly (without using local telephone company facilities).
■ Simplex Mode
— Type 5. This setting is used on 4-wire (2-pair) circuits.
400EM (Tie Trunk) Module DIP Switches
During installation of 400EM (Tie Trunk) modules, refer to Table 2–4 and
Table 2–5, and to Figure 2-11 on page 2-38
for the correct DIP switch
settings for varying signaling protocols.
Table 2-4. Setting the 400EM (Tie Trunk) Module DIP Switches
Ports DIP Signaling Type
(as numbered in
Figure 2-11)
Switch
Position
1S (Default)
and 1C
Unprotected
E&M Mode
1C and 1S
Protected
E&M Mode
5
Simplex
Mode
24
1 ON OFF OFF or ON
2 ON OFF OFF or ON
3OFF OFF ON
4OFF OFF ON
5OFF OFF ON
13
6 ON OFF OFF or ON
7 ON OFF OFF or ON
8OFF OFF ON
9OFF OFF ON
10 OFF OFF ON

Lucent Technologies MERLIN LEGEND Release 6.1 Specifications

General

Brand	Lucent Technologies
Model	MERLIN LEGEND Release 6.1
Category	Conference System
Language	English