Lucent Technologies MERLIN LEGEND Release 6.1 Installation

Connecting the Control Unit to the Network Interface
Page 4-1
MERLIN LEGEND Communications System Release 6.1
Installation
Issue 1
August 1998
MERLIN LEGEND Communications System Release 6.1
Installation
555-661-140
Issue 1
August 1998
4
Connecting the Control Unit to the
Network Interface 4
NOTE:
Refer to page 4-18 when connecting a DEFINITY ECS or
DEFINITY ProLogix to a MERLIN LEGEND Communications
System or a MERLIN LEGEND Communications System to
another MERLIN LEGEND Communications System in the same
building for correct wiring at the cross connect field.
The way you connect the control unit to the network interface depends
on the type of network interface that is installed. While there are many
ways you can do this, the methods discussed in this chapter are usually
best.
!
CAUTION:
The local telephone company is responsible for providing
appropriate protection for central office trunks. Do not
connect the central office trunks until you are certain that
they are properly protected. See “Central Office Trunk
Protection” in Chapter 2 for details.
To avoid coupling power supply noise onto system wiring,
allow at least 3 in. (7.62 cm) of clearance between the basic
carrier’s power supply and any wiring or termination
hardware located to the left of the control unit.

Lucent Technologies MERLIN LEGEND Release 6.1 Specifications

General

Brand	Lucent Technologies
Model	MERLIN LEGEND Release 6.1
Category	Conference System
Language	English