EasyManuals Logo

Lucent Technologies MERLIN LEGEND Release 6.1 Installation

Lucent Technologies MERLIN LEGEND Release 6.1
355 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #198 background imageLoading...
Page #198 background image
Installing the PC, CAT, or Printer
Page 5-1
Connecting a PC to the Control Unit
MERLIN LEGEND Communications System Release 6.1
Installation
Issue 1
August 1998
MERLIN LEGEND Communications System Release 6.1
Installation
555-661-140
Issue 1
August 1998
5
Installing the PC, CAT, or Printer 5
Once you complete the installation procedures presented in the
previous chapters, you can connect a Station Message Detail Recording
(SMDR) or Call Accounting Terminal (CAT) printer and a personal
computer (PC), or a CAT and CAT printer, to the system.
Connecting a PC to the Control Unit
You can use a PC with MS-DOS 3.3 or higher and SPM 4.15 for SMDR,
system programming, or maintenance. The method you use to connect
the PC to the control unit depends on the distance between the
hardware:
If the PC is within 50 ft. (15.2 m) of the control unit, see
“Connecting a PC Within 50 Feet” on the following page.
If the PC is more than 50 ft. (15.2 m) from the control unit, see
“Connecting a PC More Than 50 Feet Away” later on this chapter.
!
CAUTION:
To prevent damage from electrostatic discharge (ESD),
avoid touching leads, connectors, pins, and other
components. Use a properly grounded wrist strap.

Table of Contents

Other manuals for Lucent Technologies MERLIN LEGEND Release 6.1

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Lucent Technologies MERLIN LEGEND Release 6.1 and is the answer not in the manual?

Lucent Technologies MERLIN LEGEND Release 6.1 Specifications

General IconGeneral
BrandLucent Technologies
ModelMERLIN LEGEND Release 6.1
CategoryConference System
LanguageEnglish

Related product manuals