EasyManuals Logo

Lucent Technologies MERLIN LEGEND Release 6.1 Installation

Lucent Technologies MERLIN LEGEND Release 6.1
355 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #246 background imageLoading...
Page #246 background image
Initializing and Testing the System
Page 7-1
Initializing the System
MERLIN LEGEND Communications System Release 6.1
Installation
Issue 1
August 1998
MERLIN LEGEND Communications System Release 6.1
Installation
555-661-140
Issue 1
August 1998
7
Initializing and Testing the System 7
When you have finished installation, you are ready to initialize the
system as described in this chapter.
Initializing the System
To initialize a Release 6.1 system, use one of the following methods:
Restore from a 6.1 system programming disk or Translation
memory card.
Upgrade to Release 6.1 from Release 1.0, 1.1, 2.0, 2.1, 3.0, 3.1,
4.0, 4.1, 4.2, 5.0, or 6.0. See Chapter 9, “Upgrading the System.”
Use system programming forms and the procedures from one of
the guides listed in the next section, “Programming Guides.”
This section describes how to restore the system from the Translation
memory card or the system programming disk.
NOTE:
On initial installations, make sure you perform a System Erase
(frigid start), as described in
Maintenance and Troubleshooting,
either immediately before you restore from a disk or memory card
or before you program the system. Failure to perform the System
Erase (frigid start) can result in incorrect programming.

Table of Contents

Other manuals for Lucent Technologies MERLIN LEGEND Release 6.1

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Lucent Technologies MERLIN LEGEND Release 6.1 and is the answer not in the manual?

Lucent Technologies MERLIN LEGEND Release 6.1 Specifications

General IconGeneral
BrandLucent Technologies
ModelMERLIN LEGEND Release 6.1
CategoryConference System
LanguageEnglish

Related product manuals