Lucent Technologies MERLIN LEGEND Release 6.1 Installation

MERLIN LEGEND Communications System Release 6.1
Installation
555-661-140
Issue 1
August 1998
Upgrading the System
Page 9-4
Backing Up System Programming
NOTE:
When upgrading from a networked Release 6.0 system, the non-local dial
plan extension ranges must be manually programmed to suit the
customer’s configuration.
Backing Up System Programming
NOTE:
You cannot upgrade system programming for the MERLIN II
Communications System;
it must be reprogrammed. To upgrade a
MERLIN II Communications System, see “Upgrading from the MERLIN II
Communications System,” later in this chapter.
Use the following procedure to back up programming from Release 6.1
or earlier:
!Install SPM.
!Back up system programming.
See the Backup command in
System Programming and Maintenance
(SPM)
.
■ To back up system programming from Release 1.0 or 1.1 , you can
use any version of SPM (1.16 is recommended).
■ To back up system programming from Release 2.0 , you must use
SPM version 2.09 or higher.
■ To back up system programming from Release 2.1 , you must use
SPM version 2.16 or higher.
■ To back up system programming from Release 3.0 or 3.1 , you
must use SPM version 3.18 or higher.
■ To back up system programming from Release 4.0 , you must use
SPM version 4.15 or higher.
■ To back up system programming from Release 4.0, 4.1, or 4.2 ,
you must use SPM version 4.25 or higher.

Lucent Technologies MERLIN LEGEND Release 6.1 Specifications

General

Brand	Lucent Technologies
Model	MERLIN LEGEND Release 6.1
Category	Conference System
Language	English