MERLIN LEGEND Communications System Release 6.1
Installation
555-661-140
Issue 1
August 1998
Initializing and Testing the System
Page 7-18
Testing the System
!At the test telephone, pick up the handset.
!Dial the access code and the number associated with the dictation
equipment.
!Verify that the ready tone is transmitted.
!Test the transmission in both directions; make a recording and play
it back.
!Hang up.
Testing the Paging System
To test the paging system, follow the steps below:
!Pick up the handset at the test telephone and dial the number for a
particular zone.
If ZoneMate 9 paging equipment is in use with PagePac 20, get an
acknowledgment tone first and then dial the zone code to make an
announcement. You may hear a confirmation tone.
!Make an announcement into the handset.
You should hear the announcement over the loudspeaker(s).
!Hang up.
!Repeat Steps 1 through 3 for all paging zones.
Testing Music On Hold
To verify that music is provided to outside callers placed on hold, follow
the steps below. Inside callers do not hear Music On Hold.
!Pick up the handset at the test telephone.
!Dial the central office trunk access code and the system’s
published directory number; or, if you are using a DID trunk, dial
any extension.
To Next Page
Loading...
Need help?
General
