LB 9507 Chapter 8: T-Uptake/FTI-Measurements
8-13
T5
09: OPERATOR ID.
You can overwrite this and all subsequent entries. The input
sequence is the same as described in the last section from
display T6 onwards.
Move through the entries with <enter>, and edit them by
overwriting or deselecting. Here again, changes are only saved if
you exit the protocol using <YES> in the last display:
T37
09: INPUT ALL CORRECT ? YES
YES NO LAST DISPLAY
The entered parameters are only saved if you select <YES>.
T1
READY 7 MAY 00 13:58
MEASURE PROTOCOL -OTHERS-
To Next Page
Loading...