LUMAT LB 9507 - Performing Repeated Measurements

To Next Page

To Previous Page

LB 9507 Chapter 10: Kinetic Measurements

10-11

10.2.3 Performing Repeated Measurements

To perform a repeated measurement, first you have to enter a

protocol as described in chapter 10.2.2.

READY

MEASURE PROTOCOL -OTHERS-

Select <MEASURE>.

K21

SELECT TYPE OF MEASUREMENT ?

PROTOCOLS DIRECT ENTRY RATEMETER

Select <PROTOCOLS> to open a stored protocol.

K22

ENTER PROTOCOL NO. 6

PRINT LIST

Enter the number of the protocol required and press <enter>.

You can print out the list of stored protocols including number and

name by pressing the button below <PRINT LIST>.

K23

06: PROTOCOL Repeated?

YES NO

You are prompted to confirm that this is the required protocol. If

you select <NO> the program returns to display K22. <YES>

leads to:

K24

COMMENT

You can enter a comment on the following measurement using

the alphanumeric keyboard. Confirm it with <enter>. If you do not

want to enter a comment, just press <enter>.

K25

SAMPLE 1 TUBE # 1