LUMAT LB 9507 - Washing of the Injector System

To Next Page

To Previous Page

LB 9507 Chapter 11: Operator Functions

11-5

11.1.3 Washing of the injector system

This function is used to clean the injector lines with wash solution

or for priming them with suitable reagents for the subsequent

measurements.

When you select this function, you are prompted on the display to

select the injector with which to perform the washing. You can

then enter the number of the washing cycles. Load an empty tube

to collect the injected liquid. Each washing cycle corresponds to

an injection with the largest possible volume.

REAGENT FUNCTIONS:

PRIME REFRESH -OTHERS-

REAGENT FUNCTIONS:

WASH MANUAL UNLOAD -OTHERS-

Select <WASH>.

WASH

INJ1 INJ2

Select the injector with which the washing function is to be

performed.

NUMBER OF CYCLES 12

SELECTION 1 - 12

Enter the desired number of washing cycles. Each washing cycle

corresponds to an injection with the largest possible volume. The

number of injections is limited to 12 to avoid the overflowing of the

reagent. Confirm the selection by pressing <Enter>.