LUMAT LB 9507 - Page 180

To Next Page

To Previous Page

Chapter 11: Operator Functions LB 9507

11-6

INSERT TUBE

Place an empty tube for the outflowing liquid. After pressing

<START> the tube will move into the measurement position and

the washing function will be run:

INJECTION 1 1, 2, 3…x TIMES

The entered number of injections will be performed. To clean the

lines, repeat this procedure several times. Notice the capacity of

the tube.

TURN TO NEXT

REMOVE TUBE

Remove the tube.

REPEAT WASHING EXIT

If you want to repeat the function, press <REPEAT WASHING>.

The function will be repeated (see W4). The injector selection is

displayed again (see W2) by pressing the <EXIT> button.