Chapter 14: Troubleshooting LB 9507
14-2
14.3 Other Errors
Display Possible reason Solution
Tube stuck in Rotor dirty or incorrect Call Technical Service
sample holder tube measurements
Rotor not turning, Measurement chamber soiled Call Technical Service
but drive works
No display after switching Defective fuses Replace fuses, see chapter 13
on (fan not working)
14.4 Default Values
The following default values are stored in the instrument memory:
Instrument parameter Default value Configuration Default value
Injection time (s) 1.2 Language English
RLU-factor RED 1.000 CV or CVD (only CV
RLU-factor BLACK 1.000
(RLU per count)
Serial no. 0 Beeper off
Injector volume 1 0 Time format 0 - 24 h
Injector volume 2 0 Auto-smoothing YES
To Next Page