LB 9507 Chapter 3: Getting Started
3-3
3.5 System Configuration Parameters
The parameters listed in this chapter are valid for all protocols and
measurement types, and are therefore default values that are
essential for operation of the instrument (see Chapter 14.4). The
parameters entered remain stored in the luminometer, even if it is
switched off (except for the time and date, which remain stored for
approximately one month).
Please verify all configuration parameters when installing the
instrument.
These parameters are entered in the <SYSTEM
CONFIGURATION> menu. They describe the general mode of
operation of the LB 9507.
The entry menu is accessed as follows: in the main menu (with
the READY display), press the key below <OTHERS>. Press this
key again in the next display. The next display appears, containing
the <SYSTEM CONFIGURATION> menu. Press the key below
this option to display the configuration parameters.
READY <DATE> <TIME>
MEASURE PROTOCOL -OTHERS-
<DATE> <TIME>
OPER. FUNCT. TURN ONCE -OTHERS-
<DATE> <TIME>
SYST. CONFIG. INSTR.PARAM. -OTHERS-
Fig. 3-1: Operate the softkey typed in bold face to access the
configuration parameters.
To Next Page
Loading...