LB 9507 Chapter 12: Connection to External Computers
12-1
12. Connection to external computers
12.1 General
The connection cable with a 9-pin connector (ID 26204) allows the
LB 9507 to output the measured raw data and the calculated
single and averaged concentration values. For details of handling
data transfer under the Windows user interface of your PC, please
refer to the appendix A-3.
Data format:
ASCII characters, 8 data bits, no parity, 1 stop bit
Transmission rate:
19200 baud, RS 232 level.
All handshake lines are ignored in the default factory setting.
Remote control from the PC is not available.
Lumat can be connected to an Apple Macintosh using an interface
cable described in the appendix A-3.
To Next Page
Loading...