Chapter 11: Operator Functions LB 9507
11-14
11.4.2 Rerun of a 2-Point Calibrator Protocol
G0
OPERATOR FUNCTIONS:
MANUAL DATA RERUN -OTHERS-
Starting point for the Rerun option.
G1
RUN 30 PROT 12 PROLACT JAN 18 14:32
PREV. RUN PRINT LIST ENTER
The last measurement with run No., protocol No. and name, date
and time of the measurement is shown in the first line. The
measurement number also indicates the number of available
measurements. The <PRINT LIST> option prints a list of all
measurements. The run number can then be entered directly, and
display G4 appears.
<PREV. RUN> means selecting the measurement in memory.
Display G2 then appears:
G2
RUN 29 PROT 07 TSH JAN 17 11:22
PREV. RUN NEXT RUN ENTER
Selecting <PREV. RUN> moves back one measurement again.
<NEXT RUN> moves through the list of stored measurements in
the other direction to let you select one, which is then displayed
along with the most important information.
G3
RUN 28 PROT 09 T4 JAN 16 19:01
PREV. RUN NEXT RUN ENTER
<ENTER> selects the displayed measurement (in this case, "RUN
28") and leads to G4.
To Next Page
Loading...