Chapter 10: Kinetic Measurements LB 9507
10-2
10.2 Repeated Measurements
The protocol Repeated Measurement is used for long term
kinetics. Within a certain time window, samples are measured
several times. The scheme of measurement time and time
between single measurements is defined by the user. The sample
stays inside the instrument until all single measurements are
completed and the total measurement time is reached. This
measurement mode allows up to 2 injections per sample.
The displays are numbered consecutively from K1 to K34 for
clarity.
The following illustration shows a flow chart of the protocol setup
procedure and measurement start for repeated measurements.
To Next Page
Loading...