LB 9507 Chapter 10: Kinetic Measurements
10-5
K1
READY
MEASURE PROTOCOL -OTHERS-
Select the <PROTOCOL> menu by pressing the button located
directly below. The following display appears:
K2
PROTOCOL
MASTER CURVE CREATE CHANGE
The <MASTER CURVE> option is not relevant to repeated
measurements.
Select <CHANGE> to open an existing protocol by entering its
protocol number. You can then edit it.
To create a new protocol, select <CREATE>. In this casse you will
get to the following display:
K3
06: PROTOCOL NAME Repeated
The next free number is displayed for the new protocol (in our
example “06:”). Enter a name for this protocol using the
alphanumeric keyboard. You should use a name which specifies
the protocol type and other important features, so that it is easy to
identify later. For example “Repeated”.
Confirm your entry with <enter>.
K4
06: PROTOCOL TYPE
RAW DATA CUTOFF -OTHERS-
Switch to the following display by pressing <OTHERS>:
K4a
06: PROTOCOL TYPE
DL-ASSAY REPEATED -OTHERS-
Select <REPEATED>. Now you have to enter the parameters
which are the same for all protocol types:
To Next Page
Loading...