Chapter 5: Raw Data Measurements LB 9507
5-4
R1
READY
MEASURE PROTOCOL -OTHERS-
Select the <PROTOCOL> menu by pressing the button located
directly below. The following display appears:
R2
PROTOCOL
MASTER CURVE CREATE CHANGE
The <MASTER CURVE> option is not relevant to raw data
measurements.
Select <CHANGE> to open an existing protocol by entering its
protocol number. You can then edit it.
To create a new protocol, select <CREATE>. You will see this:
R3
06: PROTOCOL NAME ATP-10SEC-1INJ
The next free number is displayed for the new protocol (in our
example “06:”). Enter a name for this protocol using the
alphanumeric keyboard. You should use a name which specifies
the protocol type and other important features, so that it is easy to
identify later. For example “ATP-10SEC-1INJ”.
Confirm your entry with <enter>.
R4
06: PROTOCOL TYPE
RAW DATA CUTOFF -OTHERS-
Select <RAW DATA>. Now you have to enter the parameters
which are the same for all protocol types:
R5
06: OPERATOR ID.
Enter the user name and press <enter>.
To Next Page
Loading...