Chapter 6: CUT-OFF-Measurements LB 9507
6-2
Since negative controls often represent an important quality
criterion, limits can be set in the protocol outside which a flag is
printed.
(LOW/HIGH RLU FLAG NEG. STD.)
Also, with replicate measurements, the values may be flagged if
their variations are too high.
(% CV FLAG FOR NEG./POS. CTRLS./SAMPLES)
These options can each be turned off by entering zero.
The displays are numbered consecutively C1, C2 ...CX for clarity.
The illustration on the next page shows a flow chart from creating
protocols to starting a measurement.
To Next Page
Loading...