3-42
[7] CIGARETTE LIGHTER
This cigarette lighter is for 24V. Do not use it as the power source for 12V equipment.
This cigarette lighter (3) is used when lighting cigarettes.
When the cigarette lighter is pushed in, it will return to it‟s original
position after several seconds, so pull it out to use it.
If the cigarette lighter is removed, the socket can be used as an
85W (24V x 3.5A) power source.
[8] ROOM LAMP SWITCH
It is possible to turn ON the interior cab room lamp even when starter switch is in the OFF
position, do not forget to turn it OFF. The room lamp lights up even when starter switch is at the
OFF position.
Use this switch (8) to light up the room lamp.
• (a) ON position: Lamp lights up
• (b): OFF position: Lamp goes out.
[9] EMERGENCY PUMP DRIVE SWITCH
• This switch is provided to enable you to carry out operation temporarily, when any problem
occurs on the pump control system. Do not use it except in emergency. Furthermore, remove
the cause of the problem immediately.
• If the switch is depressed and moved to the EMERGENCY position by mistake, therby
engaging the machine in the work, while the machine is in normal condition, an “E02” mark is
shown in the display. If “E02” is displayed during the work, check that the switch is in the
NORMAL position.
This switch (9) is used to make it possible to carry out operations
temporarily if any problem should occur in the pump control
system (when the display shows “E02”).
• (a) EMERGENCY position: When abnormal (move switch up)
• (b) NORMAL position: When normal (move switch down)
If the display shows “E02”, move the switch up to make it
possible to carry out work.
To Next Page
