Maeda LC1385M-8BF - Page 93

3-29
• It is possible to change the working mode by pressing the working
mode selector switch.
When the working mode is changed, the screen returns
automatically to the camera image display screen. When this
happens, the pilot monitor display at the top centre of the monitor
screen is highlighted in yellow for 2 seconds, then returns to blue.
NOTES
For details of the method of using the working mode selector
switch, see “Operation 2.1.6 Monitor switch portion [1] Working
Mode Selector Switch”.
• It is possible to change the travel speed by pressing the travel
speed selector switch.
When the travel speed is changed, the pilot monitor display at the
top right of the monitor screen is highlighted in yellow for 2
seconds, then returns to blue.
NOTES
For details of the method of using the working mode selector
switch, see “Operation 2.1.6 Monitor switch portion [3] Travel
Speed Selector Switch”
• Press the auto-deceleration switch to return the auto-decelera-
tion function ON/OFF.
Even if the auto-deceleration switch is pressed, the camera
image display screen does not switch to another screen or return
to the standard screen display.
• It is possible to press the buzzer cancel switch to stop the alarm
buzzer for the warning item where there is an abnormality.
Even if the buzzer cancel switch is pressed, the camera image
display screen does not switch to another screen or return to the
standard screen display.
• Press the wiper switch and washer switch to operate the wiper
and washer.
Even if the wiper switch or washer switch is pressed, the camera
image display screen does not switch to another screen or return
to the standard screen display.