Mahr Digimar 817 CLM - Page 118

118
Mahr GmbH • Digimar 817 CLM
Explanation of statistical terms:
8.4.2 Display histogram and statistics
1. <-_______
2. Display histogram and statistics
3. Print out histogram and statistics
4. Histogram parameters
5. Selection criteria
............................................... Nom.val: 26.488
=================== Upp.all: 0.100
========== Low.all: -0.100
Width 0.025
< low.tol.: 0
> upp.tol.: 0
...............................................
mean val. : 26.488 Range: 0.005
Up.relia. : 26.489 Maximum: 26.491
Lo.relia. : 26.487 Minimum: 26486
Sigma : 0.002 Cm : 20.043
Up.relia. : 0.003 Cmk : 20.023
Lo.relia. : 0.001 +3Sigma : 26.493
-3Sigma : 26.483
N
o
parts : 10 Classified: 10
Program step:
1. Contact above 26.4880
2. Contact below 695360
3. Contact above 114.5620
4. Distance 45.0260
Class : 4 / 10
Mini : 91.9914
Mean : 92.0039
Maxi : 92.0163
Number: 0 / 50
( % ) : 0.0000
Select the required characteristics
With the cursor keys select a class.
Display the histogram for the chosen characteristic.
The width of the each bar depends on the number of
classes processed and is adapted automatically. The
dotted lines indicate the tolerance limits (the tolerance
limits are not shown if the measuring values lie outside
the specified standard deviation - sigma range).
Nominal value : in mm or inch.
Upp. all : Upper allowance.
Low. all : Lower allowance.
Width : Class width – computed on the basis of the tolerance window divided by the number of
classes.
Class : Number of classes.
< low. tol : Number of measuring values below the lower tolerance limit.
> upp. tol : Number of measuring values above the upper tolerance limit.
Mean value : Mean of all the measured values of a characteristic.
Up. relia. : Upper reliability limit of the mean value. Shows the limits within which the mean value of the
population lies. The reliability is 95%.